Seguir
Jamal Umer
Jamal Umer
Department of Mechanical Engineering, UET Lahore
Dirección de correo verificada de uet.edu.pk
Título
Citado por
Citado por
Año
Asperity level tribological investigation of automotive bore material and coatings
J Umer, N Morris, M Leighton, R Rahmani, S Howell-Smith, R Wild, ...
Tribology International 117, 131-140, 2018
342018
Removal of benzene as a tar model compound from a gas mixture using non-thermal plasma dielectric barrier discharge reactor
F Saleem, AH Khoja, J Umer, F Ahmad, SZ Abbas, K Zhang, A Harvey
Journal of the Energy Institute 96, 97-105, 2021
252021
Nano and microscale contact characteristics of tribofilms derived from fully formulated engine oil
J Umer, N Morris, M Leighton, R Rahmani, S Balakrishnan, H Rahnejat
Tribology International 131, 620-630, 2019
252019
SI engine performance, lubricant oil deterioration, and emission: A comparison of liquid and gaseous fuel
M Usman, MW Saleem, S Saqib, J Umer, A Naveed, ZU Hassan
Advances in Mechanical Engineering 12 (6), 1687814020930451, 2020
192020
Nanoscale frictional characterisation of base and fully formulated lubricants based on activation energy components
J Umer, N Morris, R Rahmani, S Balakrishnan, H Rahnejat
Tribology International 144, 106115, 2020
172020
Effect of Methane as an Additive in the Product Gas toward the Formation of Lower Hydrocarbons during the Decomposition of a Tar Analogue
F Saleem, J Umer, A Rehman, K Zhang, A Harvey
Energy & fuels 34 (2), 1744-1749, 2019
162019
Influence of robust drain openings and insulation standoffs on corrosion under insulation behavior of carbon steel
ARK Rana, M Yang, J Umer, T Veret, G Brigham
Corrosion 77 (6), 681-692, 2021
152021
A novel analysis of n-butanol–gasoline blends impact on spark ignition engine characteristics and lubricant oil degradation
SK Asrar Hussain, M Usman, J Umer, M Farooq, F Noor, R Anjum
Energy Sources, Part A: Recovery, Utilization, and Environmental Effects, 1-15, 2022
122022
Assessing Crop Water Requirements and a Case for Renewable-Energy-Powered Pumping System for Wheat, Cotton, and Sorghum Crops in Sudan
ZA Khan, M Imran, J Umer, S Ahmed, OE Diemuodeke, AO Abdelatif
Energies 14 (23), 8133, 2021
122021
Performance assessment and working fluid selection for novel integrated vapor compression cycle and organic rankine cycle for ultra low grade waste heat recovery
M Asim, F Kashif, J Umer, JZ Alvi, M Imran, S Khan, AW Zia, MKH Leung
Sustainability 13 (21), 11592, 2021
92021
Asperity level characterization of abrasive wear using atomic force microscopy
J Walker, J Umer, M Mohammadpour, S Theodossiades, SR Bewsher, ...
Proceedings of the Royal Society A 477 (2250), 20210103, 2021
62021
Measurements of elastic properties of biological hydrogels using atomic force microscopy
K Alam, J Umer, M Iqbal, A Hasan
Journal of Physics: Conference Series 1455 (1), 012012, 2020
52020
Influence of Insulation Stand-Off Membranes and Moisture Drainage on the Corrosion Under Insulation Behavior of Out-of-Service Carbon Steel Piping
ARK Rana, O AlChaar, J Umer, C Dromby, M Nader, G Brigham, ...
Corrosion 78 (10), 1023-1033, 2022
42022
Tribological enhancement of piston skirt conjunction using graphene-based coatings
R Hildyard, SR Bewsher, J Walker, J Umer, S Saremi-Yarahmadi, ...
Proceedings of the Institution of Mechanical Engineers, Part D: Journal of …, 2021
42021
Asperity level frictional interactions of cylinder bore materials and lubricant composition
M Forder, J Umer, N Morris, R Rahmani, S Howell-Smith, H Rahnejat
Proceedings of the Institution of Mechanical Engineers, Part J: Journal of …, 2021
42021
Thermal activation Eyring energy approach to characterise the dependence of nanoscale friction on the surface roughness
J Umer, F Saleem, M Asim, M Usman, MS Kamran, K Alam, ...
Tribology International 151, 106532, 2020
42020
Experimental study on the mechanical properties of biological hydrogels of different concentrations
K Alam, A Hasan, M Iqbal, J Umer, S Piya
Technology and Health Care 28 (6), 685-695, 2020
42020
Effect of dispersant concentration with friction modifiers and anti-wear additives on the tribofilm composition and boundary friction
J Umer, NJ Morris, R Rahmani, H Rahnejat, S Howell-Smith, ...
Journal of Tribology 143 (11), 111901, 2021
32021
Experimental evaluation of performance characteristics of a horizontal copper mesh wick-based miniature loop heat pipe
MS Kamran, K Naz, J Umer, M Sajjad, MW Saleem, MIM Zeinelabdeen
Arabian Journal for Science and Engineering 46, 2121-2132, 2021
32021
Experimental study on biological damage in bone in vibrational drilling
K Alam, M Iqbal, J Umer, M Amjad, A Al-Ghaithi
Bio-Medical Materials and Engineering 31 (5), 269-277, 2020
32020
El sistema no puede realizar la operación en estos momentos. Inténtalo de nuevo más tarde.
Artículos 1–20